C．吸入高度超出允許值。

Snction heght  is higher than allowable．

C．減低幾何吸入高度。

Lower the  suction height stepwase

d．泵的旋轉方向不對。

Direction of revolution for pump  is quite take opposite

d．檢查旋方轉向是否和泵的箭頭一致。

Check tor the diiection of revolution if it is accordance with the arrow of pump rotation

(2)

泵的流重不足

Water flow of pump is under normal.

a．吸入和壓出管系上的閘閥開啟不夠。

Gate valves on the stion and  discharge pipe are not widely

opened-

a．繼續逐漸打開各閘閥。

Open the gate valves stepwise one by one

b．旋渦工作輪和隔扳之間端面間隙過大。

plays of end-snrface between swirl

wheel and diphragn Plate become excessive

b．須減少隔扳間的調整墊片

Decrease the adjustable packing sheetc  betweentg diaphragm plates．

C．泵轉數不到額定數值。

Revolut ion perminute is under rated value

e．提高泵轉數達到額定數值。

Raise the revolut iou of pump to atttain to rated value．

(3)

消耗功率過大

power eonstlne is too high．

a．泵的壓頭太高。

Water pead for pump is too high．

a．應減低壓出壓力，繼續開啟壓出閘閥。

Lower the discharging pressure and open the pressing-discharge gate valve contiunously．

b．兩隔扳過于壓緊旋渦工作輪。

The compression pression betweeion．two diaphragmplates  is too high，resultng in clipping swirl wheel．

b．兩隔扳間再加入墊片，調整間隙。

Add some pack ing sheets  between two diaphregm plates and readjust the plays．